Asphalt Release Agent RXSOL
Part No RXSOL-90-4162-210
Asphalt Release Agent is a completely biodegradable lubricant
Overview
Asphalt Release Agent RXSOL is a completely biodegradable lubricant. The non-hazardous, water soluble mixable agent is designed to provide clean rapid and easy separation of bituminous (asphalt) materials from beds of dump trucks and haul trucks. This product is classified as Non Stick Biodegradable Agent for Asphalt.
A solvent-free, concentrated, water-based foaming asphalt release agent for use on asphalt-hauling trucks and other equipment used to handle asphalt.
Application
Prevents buildup of asphalt in truck beds.
Use as a slip coating on floor, walls, and tailgate of asphalt trucks and equipment to prevent adhesion of asphalt. Especially useful for: Building Contractors, Equipment Rental & Leasing Highway Paving Contractors
Dosage
Can be used in automated spray systems. It can be diluted with water at a ratio of 1:1 or up to 8 : 1. It can also be used in concentrated form as a cleaner for asphalt tools and equipment.
Once applied to the truck bed, a micro-thin film spreads out across the truck bed. This film creates a negative electrostatic charge on both the surface of the truck bed and the asphalt. This causes electrostatic repulsions preventing the asphalt from sticking to the surface of the truck bed.
Usually three hauls can be made before another application is required. Other Asphalt release agents require an application for each load. This product, Asphalt Release Agent Rx only requires repeated applications if hauling SMA or other polymer type mixes.
DIRECTIONS for better Asphalt Release from Truck Beds
|
Parameter |
Instructions |
|---|---|
|
Application Method |
Apply Zep Asphalt Release Agent/R-6690 using a Zep Model 294DM Foamer or a Zep Foam Cannon. |
|
Dilution Ratio |
1 part product to 7-10 parts water. |
|
Water Pressure |
Suggested foamer setting: 40-80 PSI water pressure. |
|
Air Pressure |
Air pressure should be set approximately 10 PSI higher than water pressure to produce a proper, stable foam. |
|
Application |
Apply a single layer of foam to truck walls, floors, and tailgates. |
|
Precaution |
DO NOT overspray. |
|
Equipment Cleaning |
Coat other equipment surfaces in a similar manner to aid in clean-up. |
Technical specification
| Appearance | : | Clear Pale Straw Viscous Liquid |
| Odour | : | Glycol Ether Odour |
| pH 1% Soln. | : | 7 |
| Boiling Point | : | > 212F |
| Specific Gravity | : | 0.96 g/ml |
| Viscosity | : | 10 cps |
| Solubility in Water | : | Complete |
| Misc. Physical Data | : |
NA |
Safety data sheet (MSDS)
The MSDS for Asphalt Release Agent RXSOL is sent by email. Fill in a short form and confirm your email address with a one-time code, and our team will send you the data sheet.