Skip to main content
Drag

Molecular Sieve 3A Absorbent and Catalyst

Clean Air deodorizer

Molecular Sieve 3A Absorbent and Catalyst

Part No RXSOL-24-8587-003

Reverse Emulsion Breaker 2366 is a formulation of cationic polyelectrolytes and inorganic salts used in theclarification of oil field and industrial waste waters.

Overview

Reverse Emulsion Breaker 2366 RX is a formulation of cationic polyelectrolytes and inorganic salts used in theclarification of oil field and industrial waste waters.  The product may be used in conjunction with mechanical clarification methods such as gas flotation units and hydrocyclones.

Application

Industrial waste water treatment.

Dosage

Direction For Use :

  • Reverse Emulsion Breaker 2366 (Polyfloc)c should be injected at a point in the system where agitation (natural or mechanically induced) is sufficient to mix with the fluid to be treated.
     
  • Location of the injection point for maximum efficiency will have to be determined empirically, but normally longer mixing times give the best clarification results.
     
  • If Reverse Emulsion Breaker 2366 (Polyfloc) is used in secondary treatment of oilfield waters, it should be injected upstream of the
    treating vessel in the pump suction or in the first cell.
     
  • Use concentrations can vary from 1 to 100 ppm. Initial use concentration can best be determined by jar tests, while the final use concentration will be determined in the system.
     
  • When Polyfloc is used in combination with other water clarification chemicals, injection points it should be separated enough to allow complete mixing of one before the other is introduced. Jar tests will be required to determine which order of addition is most efficient.
     
  • Clarification may in some systems may be more effective if the pH of the system is adjusted to less than 7.0.
Technical specification

Typical Properties :

Form         Viscous Liquid
Appearance Clear Pale yellow, mobile liquid;
Odour Ammonical
Viscosity @ 20°C 400 - 800 cp
Flash Point >94°C
Boiling Point >100°C
Freezing Point -12°C
pH 3.5 - 4.10
Relative density 1.14 - 1.20
Water solubility Soluble

Safety data sheet (MSDS)

The MSDS for Molecular Sieve 3A Absorbent and Catalyst is sent by email. Fill in a short form and confirm your email address with a one-time code, and our team will send you the data sheet.

Request MSDS