Antiscalant RO
Part No: RXSOL-33-3302-005
This is a reverse osmosis membrane treatment chemicals . It is highly concentrated polymer chemicals.
Scaling is caused in membranes because the level of hardness salts in the water becomes highly concentrated as it passes through the RO unit. In smaller units scale formation can be prevented by base exchange softening the make-up water but for larger systems that is very expensive. We have developed a range of easy to handle, cost effective RO Antiscalant which increase the solubility of the hardness salts so they remain in solution rather than forming scale on the membrane. Our cost effective RO antiscalants will inhibit a wide range of foulants including: calcium carbonate, calcium sulphate, barium sulphate, strontium sulphate, calcium fluoride, silica and iron.
RO Antiscalants are dosed directly to the RO feed water tank or feed water line (after pretreatment) at the recommended dosage of 1-3 mg/L and maximum dosage at 8mg/L, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content. Maximum dilution should be 10% with RO or DI water for temperature less than 30 deg C. For higher temperature the dilution ratio can increase.
Key Features and Benefits
- Inhibit scale formation and effectively controls corrosion
- Protects the membrane efficiently
- Enhance the plant operation and equipments life span
- Economical
- Easy in usage and handling
It reduces the risk of scaling and eliminates the use of hazardous acids,resulting in efficient plant operation with highest possible conversion rate.
It is a very effective antiscalant . It is also compatible with RO CHEMICALS series of coagulant and flocculants (polyelectrolytes). Our RO Antiscalant (HIGH PH) is effective in minimizing scaling in presence of foulants like Calcium Carbonate, Sulfate salts of Calcium, Barium, Strontium and Magnesium, Calcium Fluoride, Iron and Silica.
Key Features and Benefits
- Effective scale inhibition
- Alkalinity builder
- High recovery rate
- Low Chemical dosage
- Cost Effective
- Effective Iron fouling control by sequestration
- Reduced frequency of membrane cleaning
- Compatible with all types of membranes
- Completely organic and biodegradable
Application and Dosage
Our RO Antiscalant (HIGH PH) is dosed directly to the RO feed water tank or feed water line (after pretreatment) at the minimum recommended dosage of 1ppm and maximum dosage at 15ppm, subject to inlet water quality and parameters is respect of Calcium Hardness, Iron, TDS, Alkalinity, pH and silica content.
In case of high iron content of about 0.5 to 1.0ppm, the dosing has to be increased by 10-15ppm for stabilizing Calcium.
At about 10-15ppm dosage our RO Antiscalant (HIGH PH) is capable of fully inhibiting iron and calcium, and silica up to 166ppm. For higher silica content RXSOL ANTISCALANT should be used.
Antiscalant RO RXSOL-33-3302-025
Antiscalant C.I ALKA RXSOL-33-2034-025
Membrane Antiscalant ALKA 191T RXSOL-33-3321-030
Antiscalant ORG EV 2030 RXSOL-33-3325-230
Antiscalant RXSOL ORG EV RXSOL-33-3327
MSDS
| Product Name | : | RXSOL-15-1008 |
| Product Type | : | Descale Powder |
Company Details:
RX MARINE INTERNATIONAL
105, A wing , BSEL , TECH PARK.
VASHI ,NEW BOMBAY 400703 INDIA
Stock Point ::: Mumbai, Gandhidham, Kolkata, Muscat - Oman, Fujairah Middle East, Chennai, Visakhapatnam,
| Phone | : | +91 22 27815541 / 42 |
| Fax | : | +91 22 2781 1318 :::AOH :0091 9821214367 |
| : | mail @ rxmarine.com |
| Chemical Name | Concentration | CAS Number | EC Number | R Phrases* | Symbols |
| Sulphamic inhibitor blended acid | 60-100 | 5329-14-6 | 226-218-8 | 36/38, 52/53 | x |
| Non classified ingredients | 1-10 |
*See Section 16
Irritant
|
Odour |
Characteristic odour |
|
Appearance |
crystals, orange, soluble in water |
|
Contact with eyes |
Causes severe irritation |
|
Contact with skin |
In cases of severe exposure, irritation may develop |
|
Inhalation |
Irritating to respiratory system (R37) |
|
Ingestion |
The ingestion of significant quantities may cause burning sensation |
|
Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R52/53) |
|
|
Contact with skin |
Wash affected area with plenty of soap and water.Contaminated clothing should be laundered before reuse.Seek medical attention if irritation persists |
|
Contact with eyes |
If substance has got into eyes, immediately wash out with plenty of water for at least 15 minutes.Irrigate eyes thoroughly whilst lifting eyelids.Obtain immediate medical attention |
|
Ingestion |
Do not induce vomiting.Never give anything by mouth to an unconscious person.Give water or milk to drink.Obtain immediate medical attention |
|
Inhalation |
Inhalation is unlikely to occur.Remove patient to fresh air |
|
evision:31.12.2008 |
When in doubt or symptoms persist, seek medical attention |
|
General |
In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible) (S45) |
|
- Non-combustible solid - Smoke from fires is irritating - Not flammable. In case of fire use extinguishing media appropriate to surrounding conditions - Prevent run off water from entering drains if possible |
|
Personal Precautions |
Wear protective clothing as per section 8 |
|
Environmental Precautions |
Do not allow to enter public sewers and watercourses |
|
Clean Up Actions |
Sweep or shovel-up spillage and remove to a Wash spill site with water and detergent |
|
Special Precautions |
Wear protective clothing as per section 8 |
|
Handling |
Wear protective clothing as per section 8 |
|
Storage |
Keep only in the original container in a cool, well ventilated place (S3/9/49) Keep in acid store |
|
Exposure Limits |
There are no recommended or established controls for this product |
|
Exposure controls |
No special precautions are required for this product |
|
Occupational exposure controls |
Wear suitable protective clothing, including eye/face protection and gloves (plastic or rubber are recommended).Wear suitable dustmask e.g.to BS 2091 |
Gloves Suit Goggles No_Smoking
| Odour | Characteristic odour |
| Appearance | crystals, orange, soluble in water |
| pH | 1 at 10 % concentration |
| Boiling point | not applicable |
| Vapour pressure | not known |
| Melting point | 205 °C at 760 mm /Hg |
| Water solubility | ~ 200 g/l |
| Density | 1200 kg/m3 |
| Non-combustible solid | |
|
- This article is considered stable under normal conditions, In use, may form flammable/explosive vapour-air mixture (R18), Reaction products may include hydrogen - Avoid overheating - Incompatible with alkalis (strong bases) - Contact with nitrite (e.g. Diesel DEWT Guard NB NB, ROCCORRX NB Liquid) liberates toxic gas. |
|
Toxicological information |
LD50 (oral,rat) 3160 mg/kg |
|
Inhalation |
May cause severe irritation |
|
Contact with skin |
May cause irritation |
|
Contact with eyes |
Causes severe irritation |
|
Ingestion |
The ingestion of significant quantities may cause burning sensation |
|
Carcinogenicity |
No evidence of carcinogenic effects |
|
Ecotoxicity |
Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R52/53) |
|
Mobility |
Completely soluble in water |
|
Persistence and Biodegradability |
Most components in this product are not readily biodegradable. |
|
Bioaccumulation Potential |
Bioaccumulation of the components in this product is insignificant. |
|
Other Adverse Effects |
No environmental problems are expected when the product is used / handled correctly.In its intended use, the product will not be released into the environment. |
|
Classification |
EU Waste class: 06.01 This material and/or its container must be disposed of as hazardous waste |
|
Disposal considerations |
Do not discharge into drains or the environment, dispose to an authorised waste collection point Disposal should be in accordance with local, state or national legislation |
| Proper Shipping Name | ||||
| UN | ||||
| Proper Shipping Name |
Sulphamicacid, mixture |
|||
| UN NO. |
2967 |
|||
| Hazard Class | 8 | PackingGroup | III | |
|
Road/Rail(ADR/RID) |
||||
| Proper Shipping Name |
Sulphamicacid, mixture |
|||
| ADR UN No. |
2967 |
|||
|
ADRHazardClass |
8 | Tremcard |
80GC2-III |
|
| Sear (IMDG) | ||||
| Proper Shipping Name |
Sulphamicacid, mixture |
|||
| IMDG UN No. |
2967 |
|||
| IMDG Hazard Class | 8 | ICAO PackingGroup |
III |
|
| IMDG EmS | F-A, S-B | IMDG subrisk |
N/A |
|
|
IMDG Labels |
8 |
IMDG Flashpoint |
N/A |
|
|
Air(ICAO/IATA) |
||||
| ProperShippingName |
Sulphamicacid, mixture |
|||
| ICAO UnNo |
2967 |
|||
| IMDG HazardClass | 8 | ICAO PackingGroup |
III |
|
| ICAO subrisk | N/A | ICAO Labels |
8 |
|
| ICAO Flashpoint |
N/A |
|||
|
DOT/ CFR(USDepartment ofTransportation |
||||
|
DOTProperShippingName |
Sulphamicacid, mixture |
|||
|
HazardousMaterial |
Sulphamicacid |
|||
| HazardClass | 8 | Identification Number | UN2967 | |
|
Product RQ (lbs) |
N/E | DOTsubrisk |
N/A |
|
|
DOT Labels |
8 |
DOTFlashpoint | N/A | |
|
Risk Phrases |
Irritating to eyes and skin (R36/38).Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment (R52/53) |
|
Safety Phrases |
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice (S26).After contact with skin, wash immediately with plenty of soap and water (S28).Wear suitable gloves and eye/face protection (S37/39).Avoid release to the environment. Refer to special instructions/Safety data sheets (S61) |
|
Text of R and S phrase codes used in this safety data sheet:- R36/38: Irritating to eyes and skin; R52/53: Harmfulto aquatic organisms, may cause long-term adverse effects in the aquatic environment.The information provided about the product on this Safety Data Sheet has been compiled from knowledge of the individual constituents.The data given here is based on current knowledge and experience. This Safety Data Sheet describes the product in termsof safety requirements and does not signify any warranty with regard to the product's propertiesThe data given here only applies when product used for proper a pplication(s) . The product is not sold as suitable for other applications - usage in such may cause risks not mentioned in this s heet. Do not use for other application(s) without seeking advice from manufacturer DISCLAIMER OF LIABILITY :The information in this SDS was obtained from sources which we believe are reliable. However, the information is provided without any warranty, express or implied, regarding its correctness. The conditions or methods of handling, storage, use or disposal of the product are beyond our control and may be beyond our knowledge. For this and other reasons, we do not assume responsibility and expressly disclaim liability for loss, damage or expense arising out of or in any way connected with the handling, storage, use or disposal of the product. This MSDS was prepared and is to be used only for this product. If the product is used as a component in another product, this MSDS information may not be applicable. |